The Roll On Rock™ System 1 is a very easy to install Epoxy full broadcast flake coating system. System 1 uses a waterbased epoxy primer and waterbased epoxy body coat to receive the chips. When used with the 5400 Waterbased Urethane Topcoat it becomes a breathable system that is able to breathe out moisture. Another big plus for this combination is that the entire system has very low odor and is non flammable making it the system of choice for inexperienced entry level applicators or for sensative areas where odor may be an issue. System 1 has all the same topcoat options as the other Roll On Rock™ Systems. A typical installation would be to prime and then an hour later roll on the body coat and throw the flakes to rejection (about 55lbs of flake for a 2 car garage) within 10 to 20 minutes of applying the bodycoat. Then come back the next day to scrape the loose flakes off (if you save then you can use them on the next job) and then apply the clear topcoat. One coat is what most installer do but about 30% of them install 2 coats to get a higher build. VBP offers 4 different Topcoats to choose from, 3 of them are below 10 VOC and 2 of them are Low Odor and Non-Flammable. All of these topcoats will not yellow, are hot tire resistant and extremely abrasion resistant. These ultra low VOC topcoat help provide a solution for areas that are environmentaly conscious (reduce the effect on Global Warming) as well as areas that can not allow a solvent based system . All of these systems are also compliant with the new strict SCAQMD rules that became law July 2007. See the chart below for the pros and cons for each system. This range of floor coatings designed specifically for the garage floor is just one more reason why VBP is the leader in the garage floor and industrial coating industry.
Click here to go to the product home page for msds, install guides, FAQ page and more
